Remove AC and battery power from the panel.To default the main control panel hardware, perform the following: Also you will need to know if there are any add on modules or anything else special that will need to be reprogrammed. Before you reset the panel you will need an accurate list of your current zones, and whether they are hardwired or wireless, as you will need to program them all back in. Installer's Lockout is indicated by 10 rapid clicks from the phone relay on the main circuit board on power up. Note: If Installer's Lockout is enabled a hardware default cannot be performed. Note that this is not something we typically recommend for an end user to perform, except as a last resort. If the installer did not lockout the panel then this will reset it to factory defaults. If you do not have any codes to access your DSC panel, or just want to start from scratch with the programming you can do a hardware reset on the panel.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |